LOCAL MODE TELECONTROL
MODBUS (CCRS485)
The CAN RS485 Converter allows via MODBUS protocol:
The connection of the control device to another device (via MODBUS).
The supervision and control.
And extracting information of certain values and details of the generating set for control and monitoring that can be incorporated into the control system itself.
CAN/USB
The option CAN/USB is focused on the monitoring, control and configuration of a generating set connected to a PC by CAN/BUS. This mode of local telecontrol is guaranteed for a distance of less than 1km. With this type of connection the cost of communication is null.
The converter CAN/USB allows:
The connection through USB of the device to a PC. Management of the controller configuration. Total monitoring and control using Software.
CAN/LAN
The option CCLAN allows monitoring, control and configuration of the group through the connection between the controller, remote control and configuration software to an Ethernet network (Intranet). Through Pc is achieved the control of a generating set located in a building, factory, etc. This is connected to an internal local network. With this type of connection the cost of communication with the controller device of the genset is zero. Through the Software configurator of CCLAN is assigned to the converter’s IP address and communication port. Once installed the telecontrol and configuration software on any PC of the intranet, we can connect to the controller through its IP.
The converter CAN / LAN allows:
Full control via PC. Management of the configuration of the control device. Monitoring, control and configuration using Software.
REMOTE MODE TELECONTROL
CAN/RS232
CCRS232 option allows the supervision and the remote control. By means of a connection through a line modem or GPRS/GSM modem between the genset control panel and the Telecontrol and Configuration software.
CAN/RS232 module allows:
Control by PC with a conventional telephone line. (option Kit CAN/RS232 Zoom)
Control by SMS when there is not a conventional line. (option kit CAN/RS232 GSM)
Total management for the configuration of the control panel.
Remote control and monitoring.
Positioning via GPS and alarms when the genset is out of the prestablished perimeter, etc.. (option Kit CAN/RS232 + positioning).
CAN/LAN
CC/LAN option allows to carry out a connection between the control panel and the Telecontrol and Configuration Software through an Ethernet (Internet) connection.
Through this type of connection, the cost of the communication would be the same flat fare contracted for the Internet access. For this application, we need the configuration of a router with the IP and the port (re-directioned) to CC/LAN.
CAN/LAN allows as follows:
Control by PC
Total management for the configuration of the control panel.
Remote control, configuration and monitoring.
COMMUNICATION BETWEEN ENGINE AND CONTROL PANEL
J1939: Communication between engine
and control panel through protocol J1939
It makes possible the direct connection to the electronic control of the engines (ECU) which protocol of communication is based on J1939. J1939 can monitor the following parameters of the engine working depending on the manufacturer and model
Measures for pressure, temperature, battery voltage, revolutions, etc
Engine alarms diagnosis based on codes.
Run and Stop operative.
Change of speed in the engine Speed fine adjustment.
ADVANTAGES:
This module gives great advantages since
it replaces the “coordinator” used by some
engines and simplifies the cabling in order to
get readings and measurements (only CAN and
electrical supply).
